Journal of Applied Science and Engineering

Published by Tamkang University Press

1.30

Impact Factor

1.60

CiteScore

Clustering-Based Outlier Detection Technique Using PSO-KNN

A Development Of Electrode Probes For Imaging Precancerous Lesions With Electrical Impedance Tomography Technique: A Phantom Study

ANFIS Based Reduce Device Count DSTATCOM

Design And Performance Evaluation A Sliding Mode Control Based On The K Observer For A Three Tank Non-Interacting System

Reward-weighted DHER Mechanism For Multi-goal Reinforcement Learning With Application To Robotic Manipulation Control

A Calculation Method For Mineral Reserves Based On Multi-point Geostatistics

A Study Of UV-curable Offset Ink Emulsified With An Alternative Isopropyl Alcohol-free Fountain Solution

Computational Investigation Of Zn-based Single Buffer Layers Toward Cd-free High-efficiency CIGS Thin Film Solar Cells

INFLUENCE OF A MAGNETIC FIELD ON THE CHARACTERISTICS OF A P-N JUNCTION DIODE

Harmonic Current Detection And Control Of Active Power Filter Based On Signal Processing

Cellulose Isolation From Oil Palm Empty Fruit Bunch Using Different Pretreatment Processes

Leveraging RSS Data For An Improved Radiolocation Estimation Algorithm Realization In LoRaWAN Using A Two-Tier Normalization

2024 - Volume 27

A Development Of Electrode Probes For Imaging Precancerous Lesions With Electrical Impedance Tomography Technique: A Phantom Study

A Study Of UV-curable Offset Ink Emulsified With An Alternative Isopropyl Alcohol-free Fountain Solution

2023 - Volume 26

An Efficient Method For Solving The Conformable Cauchy Reaction-diffusion Partial Differential Equations

Fault Detection, Classification And Location In Power Distribution Smart Grid Using Smart Meters Data

2022 - Volume 25

Facile electrochemical synthesis of triangle-shaped graphene nanoflakes and graphene quantum dots via surfactant-assisted and defect-induced mechanism

Daylight Annual Illuminance Investigation in Elementary School Classrooms for the Tropic of Lhokseumawe, Indonesia

2021 - Volume 24

Review on fault diagnosis and active fault tolerant control of permanent magnet synchronous motor drive system

Classification of Histopathological Images for Early Detection of Breast Cancer Using Deep Learning

2020 - Volume 23

Developing a cloud EBC system with 2P-Cloud architecture

Adsorption Isotherm of NaCl from Aqueous Solutions onto Activated Carbon Cloth to Enhance Membrane Filtration

2019 - Volume 22

Preparation of Nanosilica/polyacrylate Antifog Coatings on Polycarbonate Substrates

Brightness Preserving Enhancement for Dental Digital X-ray Images Based on Entropy and Histogram Analysis

2018 - Volume 21

Development of Reusable Hybrid Test Automation Framework for Web Based Scrum Projects

Removal of Malachite Green from Aqueous Phase Using Coconut Shell Activated Carbon: Adsorption, Desorption, and Reusability Studies

2017 - Volume 20

Role of Thermal Spray Coatings on Wear, Erosion and Corrosion Behavior: A Review

Solving Capacitated Vehicle Routing Problem Using Variant Sweep and Swarm Intelligence

2016 - Volume 19

The Building Information Modeling and its Use for Data Transformation in the Structural Design Stage

Preparation of Solvent-dispersible Nano-silica Powder by Sol-gel Method

2015 - Volume 18

Integration of Cost and Schedule Using BIM

Effect of Fiber Orientation on Mechanical Properties of Sisal Fiber Reinforced Epoxy Composites

2014 - Volume 17

Vibration Control in a 101-Storey Building Using a Tuned Mass Damper

Numerical Simulation of Cu2ZnSnS4 Based Solar Cells with In2S3 Buffer Layers by SCAPS-1D

2013 - Volume 16

Effect of Silt Fines on the Durability Properties of Concrete

Numerical Simulation of Near-Field Explosion

2012 - Volume 15

Improving Mechanical Properties by KENAF Natural Long Fiber Reinforced Composite for Automotive Structures

The Micro-Air-Vehicle Golden Snitch and Its Figure-of-8 Flapping

2011 - Volume 14

Investigations into the Parameters Influencing the Dynamic Performance of 3-RRR Planar & Articulated Robot Manipulators

Current Measurement of Resistance Spot Welding Using DSP

2010 - Volume 13

A Two-Step Method for Clustering Mixed Categroical and Numeric Data

Stability Analysis of Special-Shape Arch Bridge

2009 - Volume 12

Unbiased MMSE vs. Biased MMSE Equalizers

Optimal PID Controller Design for AVR System

2008 - Volume 11

Chip Design of White LED Driver

The Argon Gas-Based Rapid Thermal Processing for TiSiX Phase Transformation

2007 - Volume 10

Anonymous Proxy Automatic Signature Schemes with Compiler Agents for (Unknown) Virus Detection

Fabrication and Characterization of Teflon AF-Coated Liquid Core Waveguide Microchannels in PDMS

2006 - Volume 9

A Post-Design of Topology Optimization for Mechanical Compliant Amplifier in MEMS

Computational Simulation and Comparison of the Effect of Different Surroundings on Wind Loads on Domed Structures

2005 - Volume 8

Design and Fabrication of RF MEMS Switch by the CMOS Process

Maximum Power Tracking for Photovoltaic Power Systems

2004 - Volume 7

A Novel Polymer Microneedle Arrays and PDMS Micromolding Technique

Experimental Investigation of Fluid Flow and Heat Transfer in Microchannels

2003 - Volume 6

Growth of Zinc Oxide Nanowires on Silicon (100)

The Impact of RTS Threshold on IEEE 802.11 MAC Protocol

2002 - Volume 5

On the Structure of Porous Poly(vinylidene fluoride) Membrane Prepared by Phase Inversion from Water-NMP-PVDF System

The Manufacture and Test of (110) Orientated Silicon Based Micro Heat Exchanger

2001 - Volume 4

Classification of Age Groups Based on Facial Features

PCAWIN Program for Jointed Concrete Pavement Design

2000 - Volume 3

A Digital Image Copyright Protection Scheme Based on Visual Cryptography

Classification of Underwater Signals Using Neural Networks

1999 - Volume 2

Dynamic Load Balance Algorithm (DLBA) for IEEE 802.11 Wireless LAN

An Object-Oriented Testing Framework Specified in Z Notation

1998 - Volume 1

The Research for the Subculture of Design Studio of the Education of Architecture:A Case Study of Department of Architecture, Tamkang University

An Approximate Analysis For Stress And Failure Potential Of Earth Slopes

Partners